標準Stands | ||||||||||||||||||||
GB/T 11017-2002《額定電壓110kV交聯聚乙烯絕緣電力電纜及其附件》 GB/T 11017-2002:Power cables with cross-linked polyethylene insulation and their accessories for rated voltage of 110kV. IEC 60840:1999 《額定電壓大于30kV(Um=36kV)至150kV(Um=170kV)擠包絕緣電力電纜及其附件-試驗方法和要求》 IEC 60840:1999 Power cables with extruded insulation and IEC 60840:1999 Power cables with extruded insulation and their accessories for rated voltages above 30kV(Um=36kV)up to 150kV (Um=170kV) Test methods and requirements |
||||||||||||||||||||
特性與用途Propety and Function | ||||||||||||||||||||
交聯聚乙烯絕緣電力電纜導體工作溫度高,傳輸容量大,電氣性能優良,電費附件簡單安裝敷設方便等優點,因此在當今電力系統中使用廣泛。 Cross-linked polyethylene insulated power cable are featured with high allowable working temperature of conductor,huge transmission capacity,excellent electric properties,simple cable accessories and convenient installment and laying, so that they are widely used in the power system today. 電纜適用于工頻額定電壓為64/110kV(Um=126kV),中心點直接接地的輸電線路系統。 The cable can be applied to the neutral-point solid grounded power transmission line system with AC.rated voltage 64/110kV(Um=126kV). |
||||||||||||||||||||
使用特性Properties of Applition | ||||||||||||||||||||
1.電纜正常運行時導體允許的長期最高溫度為90℃ 1.During the normal operation of cables,the max permissible continuous operation temperature of conductor should not exceed 90℃ 2.短路時(最長持續時間不超過5秒)電纜導體允許的最高溫度為250℃。 2.Conductor short-circuit temperature should not exceed 250℃(when max sustaining period will not exceed 5 seconds). 3.電纜安裝時允許的最小彎曲半徑一般為電纜直徑的25倍。 3.The min permissible bending radius during the cable laying is normally 25 times of the diameter of cables. 4.電纜敷設時不受落差限制。 4.Free from restrictions of level difference along the route during the cable laying. 5.低于0℃敷設時,必須預先加溫。 5.Pre-heated is needed when the temperature is below 0℃ during the cable laying. |
||||||||||||||||||||
型號名稱 Type and Description | ||||||||||||||||||||
|
||||||||||||||||||||
規格 Specification | ||||||||||||||||||||
|